If your gas geyser’s pilot light goes out repeatedly — not once, but again and again, sometimes daily — the usual troubleshooting advice (check the thermocouple, clean the orifice, check for drafts) treats it like a one-time repair. In Pakistan, it’s often not a repair problem at all. It’s gas load shedding and pressure fluctuation, and no amount of cleaning or part-replacement fixes a pilot light that goes out because the gas supply itself was interrupted.
How to Tell Which Problem You Have
If your pilot light goes out only occasionally, in windy conditions, or after months of otherwise reliable use, that’s likely a genuine component issue — a worn thermocouple, a dirty orifice, or a draft — and a technician repair is the right fix.
If your pilot light goes out frequently, at predictable times of day, or specifically during known load shedding hours, the pilot itself is probably fine — it’s simply losing gas supply and has no way to relight itself once supply returns.
The Real Fix for Load-Shedding-Related Outages
No manual relighting technique solves a problem that repeats every single day. The actual fix is removing the need to manually relight at all — an automatic ignition system detects when gas pressure returns and restarts the pilot on its own, so you stop noticing the outage in the first place.
Frequently Asked Questions
Why does my gas geyser pilot light keep going out every day?
If it's happening on a predictable, repeating basis, this is almost always gas load shedding or low pressure — not a faulty part. A component fault causes occasional or gradually worsening failures, not a clean daily pattern.
Will cleaning or replacing the thermocouple fix a pilot light that goes out from load shedding?
No — a thermocouple failure and a gas supply interruption are two different problems that happen to produce the same symptom. If your pilot goes out because gas pressure dropped, the thermocouple was working correctly; there's nothing to repair.
Is there a permanent fix for a pilot light that keeps going out due to load shedding?
Yes — an automatic ignition system removes the need to manually notice and relight the pilot at all, restarting it automatically once gas pressure is sufficient again.
How is this different from just buying a new geyser?
An automatic ignition system adds to your existing gas geyser rather than replacing it, solving the specific relighting problem without the cost of a full new unit.